How to change battery in Jeep key fob

You may be wondering How to change battery in Jeep key fob today we look at the step by step process that will enable you undertake the task without the help of a specialist

Every Jeep provides drivers with a key fob, and it should be able to last several years without ever needing any attention.

However, if the indicator light displays green flashes for about thirty seconds each time the engine is switched off may be an indication of reduced signal.

How to tell it’s time to replace the key fob battery

A fully functional jeep key fob will unlock the door in a single click so if you need multiple clicks to unlock the jeep door, this essentially means it might be time to update the battery in your Jeep key fob.

READ ALSO: This is how to take doors off Jeep Wrangler

Also if you discover that the buttons on the device are no longer functional or are slow to respond.

Fortunately, this is a straightforward procedure that you may complete by yourself.

For a start you will need to have Small Flathead Screwdriver, and New CR2032 Battery.

When you have both, proceed to change the battery by following these instructions:

First, I will tell you how to open jeep key fob

  • Insert the flathead screwdriver into the key fob seam near the keyring mount.
  • Make sure you don’t twist the screw driver as this could damage the plastic.

After that remove the old battery from its housing.

Insert the new CR2032 battery, making sure the negative side is down.

Put the circuit board into the keypad, then put the keypad into the key.

Finally, snap the two key fob halves together and that’s how to change battery in Jeep key fob